![]() RSLinx will automatically, populate the driver (“Facility, Ethernet”) and the device under it. If you do not see your device, right click on your driver (for our example it is “Facility, Ethernet”), and select “Remove” from the context menu. If you are successful (and if you have the correct EDI files installed), you will see your device (as shown below). ![]() Note that Station 63 is reserved for Driver.įor this demo, we will be adding one device with IP address of 110.14.11.50. If you have more than one device to add, click on “Add New” button to add more stations. FactoryTalk Linx was previously known as RSLinx Enterprise Edition. ofr our example, our driver is call “Facility, Ethernet”.Įnter the IP address of your device (PLC, Panelview, etc.), and once you are done, click on “Apply”. Either RSLinx Classic (version 3.51 or higher) or FactoryTalk Linx (version 5.51 or higher) will need to be run on the computer on which the versiondog server is installed. Right-click on your driver and select Configure Driver from the context menu. I have a RSLinx Classic Lite but this procedure works for all version of RSLinx. This article will show you how to do just that. That is when you have to manually intervene and enter the IP address. However, it is common (sometimes) that not all devices are detected (automatically) due to older EDI driver or for what ever “temperamental” issue RSLinx might be having at that time. After you add a new driver and close the add driver popup window, the RSLinx will automatically start populating the “device” in a tree on the left-hand side of the RSLinx application.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |